πŸ“ The way to make a unfastened tongue and groove joint // woodworking fundamentals

Share it with your friends Like

The loose-tongue and groove joint is nice for constructing furnishings. The joint is made by slicing a groove on the sting of two boards which might be to be put collectively. Then to chop a single tongue to slot in to the the grooves when they’re pressed collectively. The final a part of the method is to connect all the items collectively.

⚠️Warning: Woodworking could be doubtlessly life threatening. Don’t try any woodworking undertaking with out familiarizing your self with necessary security data concerning the instruments and procedures you’ll use. This video makes no try at protecting all required security and procedural data to securely replicate this undertaking. Independently confirm data on this video earlier than contemplating it as truth. Assume duty to your personal security and nicely being. I say this with love and concern to your nicely being.
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~

Subscribe! 🎟️ https://goo.gl/Co1oRz

Instagram πŸ“· https://www.instagram.com/_natelarge/

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
#woodworking #tablesaw #diy #woodshop #workshop #howto #maker #powertools #woodworking joint #shopmade #makeit

Comments

loopedmess says:

Cutting the middle 1/4 out of 3/4 material, set table saw to cut a 1/4 strip the run it through twice. If any remain I in the middle clean it with table saw set at 3/8. Saves time with the fancy stuff (cepting to measure blade height)

Jessica Large says:

Great video! As usual, you are very knowledgeable on your subject πŸ‘ŒπŸ» I liked the destruction demo at the end.

Write a comment

*

12 − three =