Woodworking Suggestions: Router – Chip Free Flush Trimming

Share it with your friends Like

https://www.youtube.com/person/wwgoaeditor
Woodworking Suggestions: Router – Demonstrating on cathedral raised-panel doorways, George Vondriska teaches you flush trim a curved piece of wooden to a sample template utilizing an Final Trim Bit on the router desk. His knowledgeable woodworking approach and this specialised router bit will assure you a easy, chip-free minimize on each the downhill and uphill sides of a curve.

Comments

LightGesture says:

I got kickback and can't do my arched raised panel

Klaus Madsen says:

F…. it is annoying with those signs with text at the bottom of the screen covering up the most important parts!!! The guy who have put this together must be drunk!

Matt says:

Hello George and Anyone who can help. I wanting to make my own guitar pickguards from wood. I just bought a trim router (it takes 1/4 inch shanks) The template is made from 1/4 inch MDF and my pickguard wood is 1/8 inch thick. What size Flush Trim Bit should I buy? Such as Height, Diameter, etc. PLEASE

eladtall says:

Very helpful
Thank you very much

Parme Sane says:

How do you remove the double sided tape?

DeepWaterBlack says:

that bit is $153 on Amazon, I hope to hell it cuts clean, Jeez.

camaro375 says:

How do you prevent tear out on a profile bit? Two passes or speed of the router.

Ryan Nutter says:

I couldn't figure out what in the world I was doing wrong when flush trimming curves in natural wood until this video. I tried angle of approach, feed rate, etc… and I always got chip out or near total destruction of a good piece. Thanks a bunch for the info!

Benjy Holmes says:

This is a plan I couldn’t find in Woody Hyezmar’s Woodworking Bible. But there’s something very similar to it if you google his name, you’ll see…

Tony Herrera says:

For a 1/4" flush trim bit, how much overlap should I leave with the band saw?

stefan fourie says:

I guess cut quality depend on wood being cut. Is wood in video oak?

Dennis Adams says:

The guy stopped the video before he got to the end of the end grain cut. This is where you get chip out and he did not show it. He could have shown the climb cut going backwards into this end. Plus he could introduce the pin in the table

Luis Kremer says:

traducir al español   gracias luis

John Sprofera says:

When I'm using my pattern bit I'm getting a initial kickback when easing the wood into the bit. The bearing is on bottom of the bit also it's not a compression bit so I be using a compression bit for all my pattern bits?

athena128551 says:

great idea…thanks for the tip

Write a comment

*

12 + four =